Rose electronics UC2-1x16U/E Manuál s instrukcemi stáhnout pdf (Strana 58)

52 ULTRACONSOLE INSTALLATION AND OPERATIONS MANUAL

Kernel halt error messages

Message

Description

BAD Address = nn

Kernel memory is corrupt, hardware failure.

Resetting to factory

defaults

A memory error is detected during a read

from configuration memory. This also

indicates a hardware failure, but the system

may continue to initialize successfully. The

configuration from another Unit should be

saved to this Unit as soon as possible.

Unit Halted

A major error has forced the kernel to stop

processing. The UltraConsole waits to

receive a kernel or main firmware file from

the bottom board’s serial port using the serial

parameters: 9600, N, 8, 1. Connect the serial

cable supplied with the UltraConsole as

described in the Serial Port section, start a

terminal emulator and transfer the file using

an ASCII file transfer protocol.

Kernel is bad, load

new kernel through

serial port.

The UltraConsole waits to receive a kernel or

main firmware file from the bottom board’s

serial port using the serial parameters: 9600,

N, 8, 1. Connect the serial cable supplied

with the UltraConsole as described in the

Serial Port Section, start a terminal emulator

and transfer the file using an ASCII file

transfer protocol.

Checksum error

The kernel writes this message at power up

when a memory error is detected during a

read from program memory.

1 2 ... 53 54 55 56 57 58 59 60 61 62

Žádné komentáře

Rose electronics UC2-1x16U/E Manuál s instrukcemi Strana 58